Log placement – Empire Comfort Systems LSU18RR-1 User Manual

Page 4

Advertising
background image

23370-1-1107

Page 4

PROPER INSTALLATION SEQUENCE:
ATTENTION: For the instructions below, "Front" indicates the side of the burner with the valve.

1. With the valve "front" side facing you, place Back Right Log (log A) onto right back pins of burner.

2. Place Right Middle Log (log B) onto right middle pins of burner.

3. Place Left Back Log (log C) onto left back pins of burner.

4. Place Left Middle Log (log D) onto left middle pins of burner.

5. Place Right Front Log (log E) onto right front pin of burner.

6. Place Center Middle Log (log F) onto burner top against logs B and D. Note: Omit this step for 18" log sets.

7. Place Left Front Log (log G) onto left front pins of burner.

Before you begin: Do not, handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling logs,

wash your hands gently with soap and water.
All Logs

The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are

not properly and firmly positioned in the appliance.
Refer to Figure 1 for the following warning.

Warning: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this

appliance may result in property damage or personal injury.

LOG PLACEMENT

Figure 1

Advertising
This manual is related to the following products: