Operation, How to use your tiller – Electrolux FN620K User Manual

Page 7

Advertising
background image

7

OPERATION

The operation of any tiller can result in foreign objects thrown into the eyes, which can
result in severe eye damage. Always wear safety glasses or eye shields before starting
your tiller and while tilling. We recommend a wide vision safety mask over spectacles or
standard safety glasses.

TRANSPORTING YOUR TILLER

CAUTION: Before lifting or trans port ing,
allow tiller engine and muffl er to cool.
Disconnect spark plug wire. Drain
gasoline from fuel tank.

AROUND THE YARD
• Tip depth stake forward until it is held by the stake

spring.

• Push tiller handles down, raising tines off the ground.
• Push or pull tiller to desired location.

AROUND TOWN
• Disconnect spark plug wire.
• Drain fuel tank.
• Transport in upright position to prevent oil leakage.

FORWARD TINE CON TROL
IN “OFF ” (UP) POSITION

CHOKE
CONTROL

THROTTLE
CONTROL

FORWARD TINE CON-
TROL IN “ON” (DOWN)
POSITION

FIG. 5

STOPPING (See Fig. 5)

TINES
• Release tine control to stop move ment.

ENGINE
• Move throttle control to “STOP” position.
• Never use choke to stop engine.

HOW TO USE YOUR TILLER

Know how to operate all controls before adding fuel and
oil or attempting to start engine.

TINE OPERATION (See Fig. 5)

• Squeeze tine control to handle.

TILLING

The speed and depth of tilling is regulated by the position
of the depth stake and wheel height.

The depth stake should always be below the wheels for
digging. It serves as a brake to slow the tiller’s forward
motion to enable the tines to penetrate the ground. Also,
the more the depth stake is lowered into the ground the
deeper the tines will dig.

DEPTH STAKE (See Fig. 6)

Adjust depth stake by removing the hairpin clip and clevis
pin. Change depth stake to desired position. Replace the
clevis pin and hairpin clip.
• For normal tilling, set depth stake at the second or third

hole from the top.

WHEELS (See Fig. 6)

Adjust wheels by removing the hairpin clip and clevis pin.
Change wheel position. Replace the hairpin clip and clevis
pin.
• For normal tilling, set wheels at the second or third

hole from the top.

DEPTH
STAKE

STAKE
SPRING

HAIRPIN CLIP
AND CLEVIS PIN

WHEEL

FIG. 6

Advertising