Elektra Beckum DH 315 - Manual (Page 5)

3
DH 315
Safety devices
Anti-kickback lock (A)
The anti-kickback lock prevents a workpiece being
thrown back against the operator by the rotating
cutterblock.
The anti-kickback lock must not be bent.
Cutterblock cover (B)
The cutterblock cover prevents that the upper part
of the cutterblock can be touched from the top.
While the machine is not unplugged and the cutter-
block has not stopped, the cutterblock cover must
be installed.
Instead of the cutterblock cover a dust extraction
adaptor can be installed.
Operating controls
On/off switch
·
To switch ON = press green switch button.
To switch OFF = press red switch button.
3 An undervoltage relay trips in the event of a
voltage failure, to prevent a restarting of the
machine when the power is restored. To
restart the machine the green button must be
actuated again.
Reset button for overload relay
The planer/thicknesser has a build-in overload pro-
tection (arrow). This stops the machine if the motor
becomes too hot. To restart the planer/thicknesser:
1. If necessary, let motor cool down;
2. depress the reset button;
3. press green switch button.
Rise and fall mechanism
With the rise and fall mechanism the planing thick-
ness (= workpiece thickness
after thicknessing) is
set. Workpieces of up to max. 153 mm thickness
can be worked.
DO WN
UP
A
B
DO
WN
UP