Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4G4285-49 - Manual (Page 35)

Enterasys Matrix DFE-Gold Series PoE Module Hardware Installation Guide 3-1
3
Installation
This chapter provides the instructions to install the 4G4285‐49 and 4G4205‐72 DFE
modules. Follow the order of the sections listed below to correctly install the DFE
modules.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
Important Notice
Read the Release Notes shipped with the DFE module to check for any exceptions to the supported
features and operation documented in this guide.
For information about... Refer to page...
Installation Site Requirement 3-2
Unpacking the DFE Module 3-2
Installing Optional Network Expansion Modules 3-3
DFE Module Placement and Installation Rules 3-3
Preparing to Install Module into Matrix E7 or N7 Chassis 3-7
Installing the DFE Modules into Matrix N3 or Matrix N5 Chassis 3-11
Connecting to the Network 3-14
Connecting to COM Port for Local Management 3-20
Completing the Installation 3-26