Enterasys Networks 5H102-48 - Manual (Page 32)

Connecting to the Network
3-8 Installation
3.3.2 Connecting UTP Cables to the 5H103-48
When facing the front panel of the 5H103-48, the RJ21 connectors from top to bottom represent
Ethernet/Fast Ethernet segments 1 through 12, segments 13 through 24, 25 through 36, and 37
through 48, respectively.
To connect a UTP segment to the 5H103-48, proceed as follows:
1. Ensure that the device connected to the other end of the segment is powered ON.
2. If using an RJ21 straight connector, plug it into the appropriate RJ21 port as shown in
Figure 3-5 . If using an RJ21 angle adapter supplied with the switch, insert the angle adapter as
shown in Figure 3-6 . The RJ21 angle adapter allows the cables to be positioned along the front
of the device when using a right angle RJ21 connector. See example in Figure 3-7 .
Figure 3-5 Connecting a Twisted Pair Segment to the 5H103-48
35861_06
FAST ENET
5H103-48
GROUP
GROUP
SELECT
RESET
COM
CPU
GROUP
24X
1X
12X
G
R
O
U
P
1
Screw Hole
Screw Hole
Link
Status
LEDs
Screw
Screw
RJ21