Trouble shooter and service, Frost precautions – Electrolux L 75478 FL User Manual

Page 22

Advertising
background image

When you drain the water with the
emergency drain procedure, you must
activate again the drain system:
1. Put 2 litres of water in the main wash

compartment of the detergent dis-
penser.

2. Start the programme to drain the

water.

FROST PRECAUTIONS

If the appliance is installed in an area
where the temperature can be less than
0 °C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.
3. Remove the water inlet hose
4. Put the two ends of the inlet hose in

a container and let the water flow
out of the hose.

5. Empty the drain pump. Refer to the

emergency drain procedure

6. When the drain pump is empty, in-

stall the inlet hose again.

WARNING!
Make sure that the temperature
is more than 0 °C before you
use the appliance again.
The manufacturer is not respon-
sible for damages caused by
low temperatures.

TROUBLE SHOOTER AND SERVICE

The start of the appliance does not oc-
cur or it stops during operation.
First try to find a solution to the prob-
lem (refer to the table). If not, contact
the service centre.

With some problems, the acoustic
signals operate and the display
shows an alarm code:

- The appliance does not fill

with water.

- The appliance does not drain

the water.

- The appliance door is open or

not closed correctly.

- The anti-flood device is on.

WARNING!
Deactivate the appliance before
you do the checks.

Problem

Possible cause

Possible solution

The appliance
does not fill with
water.

The water tap is closed.

Open the water tap.

The water inlet hose is
damaged.

Make sure that the water inlet
hose has no damages.

The filters in the water in-
let hose is blocked .

Clean the filters. Refer to 'Care
and cleaning'.

The water tap is blocked
or is furred with lime-
scale.

Clean the water tap.

The connection of the
water inlet hose is not
correct.

Make sure that the connection is
correct.

The water pressure is too
low.

Contact your local water authori-
ty.

The appliance
does not drain the
water.

The water drain hose is
damaged.

Make sure that the water drain
hose has no damages.

22

Advertising
This manual is related to the following products: