Enterasys Networks 6H308-24 - Manual (Page 43)

Using the RESET Button
Troubleshooting 4-7
4.3 USING THE RESET BUTTON
The RESET button shown in Figure 4-2 resets and re-initializes the module.
Figure 4-2 RESET Button
To reset the module processor, press and release the RESET button. The module goes through a
reset process for approximately 60 seconds. Additional downtime may result as the module
reenters the network.
CAUTION: Pressing the RESET button resets the device, and all current switching
being performed by the module is halted. A network downtime of up to two minutes will
result from this action for any devices connected to the module.
NOTE: Pressing the RESET button while the module is already in reset mode is not
recommended. If the RESET button is pressed while the module is in reset mode, the
module will enter an extended diagnostic procedure, which is unnecessary for normal
operation. This extended diagnostic procedure takes longer than one minute to
complete.
3549_06
RESET
C
O
M
CPU
GROUP
GROUP
SELECT
4
1X
G
R
O
U
P
3
1X
G
R
O
U
P
1
RX TX
RX TX
RX TX
RX TX
RX TX
RX TX
RX TX
RX TX
RX TX
RX TX
RX TX
RX TX
RX TX
RX TX
FAST ENET
6H308-48
RESET Button