EverFocus COLOR DOME ED300E - Manual (Page 4)

3
○
1 Camera Cover
This cover will protect the camera for avoiding dust and damage.
○
2 Lens
This vari-focal Lens allows users to adjust the Zoom and Focus manually.
Built-in fixed lens: 3.6; 4.3; 6.0 or 8.0 mm
○
3 Base
The camera unit sets in the dome base, when it is shipping from the factory.
○
4 Focus Ring (for vari-focal lens only)
To set the focus, and loosen the Focus ring knob, please turn the ring toward <F> or <N> if
necessary.
○
5 Zoom Ring (for vari-focal lens only)
If you like to adjust the viewing range, please loosen or tighten the Zoom ring. Turn the ring
towards <W> for Zoom out or <T> for Zoom in. When camera setting is finished, please
tighten the zoom ring knob.
○
6 Flickerless
The factory setting is FL OFF.
○
7 Mirror
The factory setting is Mirror OFF.
○
8 Auto Gain control on/off switch
The factory setting is AGC ON.
○
9 D/N
The factory setting is D/N OFF.
○
10 Monitor Test Pin
For monitor use. When setting up the camera, connect a monitor to this video output pin and
to the GROUND pin using alligator clip cables, then use the image displayed on the monitor,
set the surveillance angle.
○
11 Level Volume Control (for vari-focal lens only)
The iris level control for the lens.