Denon AVR-X1700H 7.2-Channel Network A/V Receiver with HEOS - Manual (Page 179)

3
Connect the Sound calibration microphone to the
SETUP MIC jack of this unit.
.
When the Sound calibration microphone is
connected, the following screen is displayed.
.
Audyssey Setup
Your AV receiver can automatically measure the
acoustics of your room then optimize your
speakers using the included microphone
and microphone stand.
Next Back
4
Select “Next”, then press ENTER.
5
Select “Start”, then press ENTER.
Audyssey ® Setup can also make the following settings.
0
Amp Assign
The signals output from the SURROUND BACK speaker
terminals can be switched in accordance with your speaker
environment. (“Amp Assign” ( v p. 187))
0
Channel Select
If channels that are not to be used are set in advance,
measurement for the set channels is skipped, and measuring
time can be reduced. You can also change the number of
surround back speakers.
0
Dolby Sp.Setup
Set the distance between the Dolby Atmos Enabled speaker and
the ceiling.
This can be set when “Assign Mode” is set to “Front Dolby” or
“Surround Dolby” in the “Amp Assign” settings. ( v p. 187)
.
Audyssey Setup
Set the following items if necessary.
Start
Back
Dolby Sp.Setup
Channel Select
Amp Assign
Contents Connections Playback Settings Tips Appendix
179
Front panel Display Rear panel Remote Index