Electrolux 2170-4 - Manual (Page 25)

Something not Working
818 14 33-00/7 25
If after the above checks there is still a fault, call your local AEG Service
Force Centre.
In-guarantee customers should ensure that the above checks have been
made as the engineer will make a charge if the fault is not a mechani-
cal or electrical breakdown.
Please note that proof of purchase is required for in-guarantee service
calls.
The temperature in the freezer is too high.
Check the ambient temperature is within
the appliances operating limits
Check the temperature regulator is turned
to the correct setting relative to ambient
conditions.
The compressor runs continuously
Adjust the temperature regulator to give
correct temperature control.
Check that the door is closed.
Large quantities of food have recently
been placed in the cabinet and/or door is
frequently opened.
Check that air ventilation is not
obstructed.
Excessive build up of frost.
If the door seal is not airtight (probably
after changing over the door hinges)
apply warm air to the non sealing area
using a hair dryer set to a gentle heat. (do
not use a fan heater for this purpose).
This will make the rubber more supple
and allow it to revert to its original shape.
Noise Refer to Normal Operating Sounds
The compressor does not start immedia-
tely after changing the temperature set-
ting.
This is normal, the compressor starts after
a period of time.
Sympton Solution