Edimax Technology HP-8501 - Manual (Page 12)

EDIMAX HP-8501
Quick Installation Guide
8
The lower panel displays all the Powerline Ethernet devices, discovered on the current logical network (remote
devices). The number of remote devices found, the type of logical network (Public or Private), and a message
area that reports connectivity and scan status will be displayed above this panel. The following information is
displayed for each devices found:
Device Name column shows the name of a found device. You can click on the name or click ‘Rename’ to change
the name of a selected device. An icon is optionally shown with the name.You can identify the speed of a device
by its icon (14Mbps or 85Mbps). By default, the icon is displayed with the name.
MAC Address column shows the device's MAC address.
Password column shows the user-defined device password (initially left blank).
A user may change the password by clicking ‘Set Password’ button. To set the Password of the device (required
when creating a secured private network), first select the device by clicking on its name in the lower panel and
then click on the ‘Enter Password’ button .A dialog box will appear as shown in Figure 5 for you to type the
password. The selected device name is shown so you can make sure which device you’re changing the password.
Click OK after you’ve enteried the new password. A confirmation box will appear if the password was entered
correctly. If a device is not found, the user will be prompted and instructions to this problem will be shown, too.
Figure 5: Set Device Password