Eiki LC-SX6A - Manual (Page 6)

6
Safety Instructions
Openings in the cabinet are provided for ventilation and to
ensure reliable operation of the product and to protect it from
overheating, and these openings must not be blocked or
covered.
CAUTION
Hot air is exhausted from the exhaust vent. When using or
installing the projector, the following precautions should be
taken.
– Do not put any flammable objects or spray can near the
projector. Hot air is exhausted from ventilation holes.
– Keep the exhaust vent at least 3.3’ (1m) away from any
objects.
– Do not touch a peripheral part of the exhaust vent,
especially screws and metallic part. This area will become
hot while the projector is being used.
– Do not put anything on the cabinet. The materials put on
the cabinet will not only get damaged but also cause fire
hazard by heat.
Cooling fans are provided to cool down the projector. The
fan's running speed is changed according to the temperature
inside the projector.
Air Intake Vent
Exhaust Vent
(Hot air exhaust)
Do not tilt the projector more than 20
degrees from side to side.
In upward projection, do not tilt the
projector over 20 degrees right and
left.
Do not put the projector on either side
to project an image.
20˚
20˚
In downward projection, do not tilt the
projector over 20 degrees right and
left.
Use the projector properly in specified positions. Improper
positioning may reduce the lamp life and result in severe
accident or fire hazard.
This projector is allowed to project the picture in any position
of 360 degrees such as upward, downward, or backward as
below.
Bottom
Downward
(Usual)
Front
Downward
Bottom
Upward
Front
Upward
Setup In Proper Directions
When installing the projector, avoid positioning it as described
below:
Positioning Precautions
Air Circulation