Troubleshooting guide, Maintenance, Evolution control line engine specifications – Evolution Technologies 36NT User Manual
Page 7: Engine won’t fire, Engine quits repeatedly, Engine runs inconsistently, After each flying session
7
Troubleshooting Guide
Engine Won’t Fire
• Glow starter not charged
- Charge glow starter
• Glow plug burnt out
- Replace glow plug
• No fuel is getting to the carburetor
- Check tank, fuel lines reversed
• The starter is reversed
- Reverse the polarity on the starter cables
Engine Quits Repeatedly
• Needles need adjusting
- See adjustment procedure
• Bad or old fuel
- Replace with fresh fuel
• Worn out glow plug
- Replace with new EVOGP1 super plug
Engine Runs Inconsistently
• Hole in fuel line
- Replace fuel line
• Bad or old fuel
- Replace with fresh fuel
Maintenance
After each flying session:
1. Fully drain the fuel from the tank.
2. Start the engine and run it until the fuel is
completely run out of the engine.
3. Try starting the engine three more times or until
it will no longer fire. This gets all the fuel out of
the engine.
At the end of every flying session, several drops (about
10) of after-run oil (Evolution Engine's Blue Block Rust
Inhibitor) should be applied into the venturi and the
engine should be flipped over for a few seconds with the
starter. This will prevent rust and corrosion.
If you need additional help or have any questions, please call Horizon’s Service Center.
Horizon has trained technicians who are qualified to answer your engine questions.
Evolution/Horizon Service Center
4105 Fieldstone Road
Champaign, IL 61822
877-504-0233
European Union:
Electronics and engines requiring inspection or repair should be shipped to one of the
following addresses:
Horizon Hobby UK
Units 1-4 Ployters Rd
Staple Tye, Southern Way
Harlow
Essex CM18 7NS, United Kingdom
Please call +44 1279 641 097 or [email protected] with any questions or
concerns regarding this product or warranty.
Horizon Technischer Service
Otto Hahn Str. 9a
25337 Elmshorn
Germany
Please call +49 4121 46199 66 or [email protected] with any questions or
concerns regarding this product or warranty.
Disp Bore Stroke Weight
Crank K
Items
(c.i.) (mm) (mm)
(oz)
(ISO)
Cylinder Propeller
EVOE0365
.354" .806"
.695"
9.2
1/4X28
ABC
11x4 or 11x5
Evolution Control Line Engine Specifications
Dimensions(mm)
A
B
C
D
E
F
G
H
EVOE0365
30
38
15
47
78
72
1/4X28
37
F
H
G
A
D
C
E = height
F = length
G = crankshaft thread size
H = muffler bolt spacing
B