RCF 710-A MK4 - 10" 2-Way 1400W Active Speaker User Manual
Page 6
6
ENGLISH
CONNECTIONS
The XLR connectors use the following AES standard:
PIN 1 = GROUND (SHIELD)
PIN 2 = HOT (+)
PIN 3 = COLD (-)
BEFORE CONNECTING THE SPEAKER
On the back panel you will find all the controls, the signal and current inputs. At first verify that the voltage selector on the speaker is in proper
position for your country (115 Volt or 230 Volt).
The switch shall be in proper position (unless moved from unauthorized people), but a fast check will avoid problems. In case is necessary to
change the voltage please call your vendor or authorized RCF SERVICE CENTRE. This operation require the substitution of the fuse value and
is reserved to an RCF SERVICE CENTRE.
BEFORE TURNING ON THE SPEAKER
At this point you can connect the power supply cable and the signal cable, but before turning on the speaker make sure that the volume
control is at the minimum level (even on the mixer output). It is important that the mixer is already ON before turning on the speaker. This will
avoid damage to the speakers and noisy “bumps” due to turning on parts on the audio chain. It is a good practice to always turn on speakers
at last and turn them off immediately after the show.
Now you can turn ON the speaker and adjust the volume control to a proper level.
INSTALLATION
A 35 mm socket for mounting the loudspeaker on a speaker stand is provided in the bottom of the cabinet. ART speakers MUST be used only
with approved rigging hardware.
WARNING: Never suspend ART speakers by there handles. Handles are intended for transportation, not for rigging.
WARNING:
The use of these speakers with Stand and Pole Mount accessories can be done by qualified and experienced personnel only,
trained appropriately on professional systems installations. In any case it’s the user’s final responsibility to ensure the system safety conditions
and avoid any danger or damage to people, animals and objects.
WARNING:
To use this product with the subwoofer pole-mount, before installing the system, please verify the allowed configurations and
the indications regarding the accessories, on the RCF website to avoid any danger and damages to people, animals and objects. In any case,
please assure the subwoofer which is holding the speaker is located on an horizontal floor and without inclinations.
PROTECTIONS
ART Series active speakers are equipped with a complete system of protection circuits. Two led on the amplifier back panel indicate the
working status of the amplifier: the green led indicate that the speaker is ON and the red led is on when the protection circuit is active. The
circuit is acting very gently on audio signal, controlling level and maintaining distortion at acceptable level. If this led is ON for a long period
is better to reduce immediately the signal level from the mixer or from the speaker volume control.
VOLTAGE SETUP (RESERVED TO THE RCF SERVICE CENTRE)
200-240 Volt, 50 Hz SETUP:
FUSE VALUE T 3.15 A L 250V
100-120 Volt, 60 Hz SETUP:
FUSE VALUE T6.3 A L 250V
IMPORTANT
NOTES
1
2
3
HOT
COLD
GND
BAL. XLR