LD Systems CURV 500 AVS Portable Array System AV Set with Speaker Cables (Black) - Manual (Page 6)

6
DEUTSCH
ENGLISH
FRANCAIS
ESP
AÑOL
POLSKI
IT
ALIANO
•••
CONNECTIONS, CONTROLS AND INDICATORS
1 3 4 4
5 6
7
2
8 9 10 10
LDCURV500S
1 INPUT MIC/HI-Z
Balanced microphone or instrument input (XLR / 6.3 mm jack combo). It is also possible to use an unbalanced microphone or instrument
cable (mono jack). Pay attention to the setting of switch 2, as described below. NOTE: The XLR input socket is designed for the 12 V
phantom power supply of a condenser microphone.
2 HI-Z SWITCH
When using channel 1 as a microphone channel, bring the HI-Z switch to the up position. When using channel 1 as an instrument channel,
bring the HI-Z switch to the down position.
3 INPUT MIC
Balanced microphone input (XLR / 6.3 mm jack combo) It is also possible to use an unbalanced microphone cable (mono jack). NOTE: The
XLR input socket is designed for the 12 V phantom power supply of a condenser microphone.
4 INPUT LINE 3 + 4
Balanced line inputs with XLR / 6.3 mm jack combo sockets for connecting a playback device (e.g. mixer, keyboard). When using a CURV
500 ® ES Entertainer Set as a Mono Set (the array satellites mounted together on the spacer bar), the MONO / STEREO (26) switch on the
mixer control panel must be pressed down (MONO). An incoming audio signal will be mono summed. When using a CURV 500 ® ES
Entertainer Set as a Stereo Set (2 array satellites mounted left and right), or using the CURV 500 ® PS Power Set (Stereo), the MONO /
STEREO (26) switch on the mixer control panel must not be pressed down (STEREO). An incoming stereo audio signal will be output in
stereo. The latter also applies when using the LD CURV 500 ® AVS Stereo A/V Set (switch 26 -> STEREO).
5 LINE OUT MONO MIX
Balanced line output with male XLR socket. Output of the mixer summing signal in Mono.
6 SYSTEM OUT CURV 500 SE
Male 5-pin XLR socket to connect the CURV 500 ® SE Subwoofer expansion, or the CURV 500 ® PES Power expansion sets. When using a
CURV 500 ® SE Subwoofer expansion, the MONO / STEREO (26) switch on the mixer control panel must be pressed down (MONO). An
incoming audio signal will be mono summed. When using a CURV 500 ® PES Power Expansion Set to create a Stereo Set, the MONO /
STEREO (26) switch on the mixer control panel must not be pressed down (STEREO). An incoming stereo signal on INPUT LINE 3 / 4 will be
output in stereo.