EverFocus EDSR 400F - Manual (Page 13)

E V E R F O C U S E L E C T R O N I C S C O R P O R A T I O N
Basic Wiring Instructions
Please refer to diagram 1 on page 9 to assist you with this portion of the installation.
¾ Power: Connect the power source or adapter into the power socket shown in
diagram 1.
ƒ Please Note: Do not plug the digital video recorder into the same
power source as the cameras.
¾ Cameras: Connect each cameras video output to the video input (bottom
row) on the digital video recorder shown in diagram 1.
ƒ Please Note: At least one camera must be connected before the system
is running for the auto detection of video standard to take effect.
¾ Audio Input: Connect the according audio device refereed on chapter 7.
¾ Audio Output: Connect the according audio device refereed on chapter 7.
¾ Ethernet: The digital video recorder may be viewed from a PC via the LAN
connector using a RJ45 Ethernet cable.
¾ RS232/RS485: The digital video recorder may be controlled from a PC via
RS232/RS485.
ƒ Please Note: This can be done using a serial cable.
¾ Main Monitor: Connect the main monitor output connector to a main
monitor. The main monitor displays selected live or recorded cameras in any
available format.
ƒ Please Note: The main monitor must be connected in order to make
configuration changes, enter the main menu, or do a playback at the
machine.
¾ Call and Matrix Monitors: Connect the call and matrix monitor output
connectors to a call or matrix monitor. The call and matrix monitors display
selected live cameras in full screen format.
ƒ Please Note: The call monitor will only display one full screen camera
at a time.
8