Log placement – Empire Comfort Systems LS-18H-1 User Manual

Page 4

Advertising
background image

Page 4

20173-3-0806

PROPER INSTALLATION SEQUENCE:
LS-(18, 24, 30)H

(Figure 1)

1. Place rear (#2) log between rear log support and onto burner

pan pins.

2. Place front (#1) log onto pins on burner pan.
3. Place top log (#3) onto (2 pins) front log.
4. Compare the completed log installation with the appropriate

photo from pages 5 through 7. Review previous steps to make

any necessary adjustments.

5. Log placement is completed.
Attention: Do not use Figure 1 to order replacement logs. Refer to

Page 8, Parts List and Parts View to order logs for your appropriate

model number.
Apply loose material (glowing embers) per appropriate Installation

Instructions and Owner's Manual. Replacement of loose material

(glowing embers) must be purchased from Empire Comfort

Systems, Inc. Application of excess loose material (glowing

embers) may adversely affect performance of the heater.

WARNING: All previously applied loose material must be

removed prior to reapplication.
Replacement Loose Material (glowing embers) Part

Number

LS-18H

15999

LS-24H

15970

LS-30H

15970

Platinum Bright Embers PE-20-1

Note: A single layer of embers is to be used when applying

Platinum Bright Embers (alone or in combination with production

embers) to the burner.

Before you begin: Do not, handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling logs,

wash your hands gently with soap and water.
All Logs

The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are

not properly and firmly positioned in the appliance.
Refer to Figure 1 for the following warning.

Warning: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this

appliance may result in property damage or personal injury.

Log Placement

LS-(18, 24, 30)H Logs

Figure 1

The following WARNING applies when log set is installed onto

an unvented gas burner assembly.

WARNING: This appliance is equipped for (natural or

propane) gas. Field conversion is not permitted.

1

3

2

LOG PLACEMENT

Advertising
This manual is related to the following products: