Eclipse - Fujitsu Ten AVN5435 EN - Manual (Page 100)

99
Remote cont
rol
Replacing the battery
Use one CR2025 battery.
#
On the back of the remote control, while
pressing the locking knob on the battery slot
cover toward your right, pull out the battery
carrier with your fingernail.
$
Remove the old battery, then place the new one
in the carrier with the mark facing up.
%
Push in the carrier until it snaps into place.
To prevent accidents, store batteries out of the reach of children. If a child has
swallowed one, consult a doctor immediately.
Unlock
Be sure to orient the batteries correctly so that the positive and negative poles
match the diagram.
If any liquid is seen leaking from the battery, remove the battery and dispose of it
properly. Thoroughly clean the battery compartment with a dry cloth. Then install
new battery.