Electrolux EOD43102 - Manual (Page 28)

28
electrolux care and cleaning
Care and cleaning
Before cleaning always allow the
appliance to cool down before
switching off at the electricity
supply.
Cleaning materials
Before using any cleaning materials on
your appliance, check that they are
suitable and that their use is
recommended by the manufacturer.
Cleaners that contain bleach should
not be used as they may dull the
surface finishes. Harsh abrasives and
scourers should also be avoided.
Cleaning the outside of the
appliance
Do not use abrasive cleaning materials
e.g. abrasive cream cleaners, wire wool
pads or scourers on painted or printed
finishes as damage may occur.
Regularly wipe over the control panel,
control knobs, handles, doors and
appliance sides using a soft cloth and
hot soapy water. To prevent streaking,
finish with a soft cloth.
Stainless Steel cream cleaners are
abrasive and should be avoided as
they may dull the surface finish. Any
spillage on the stainless steel finish
must be wiped off immediately.
Do not attempt to remove any of
the control knobs from the
appliance as this may cause
damage and is a safety hazard.
Removing and replacing the
wirework runners
1. Remove all shelves
and furniture from
the oven.
2. Hold the wirework
at the bottom,
unclip from the
cavity side and
gently pull towards
the centre of the
oven.
3. Unhook the runner
at the top and
remove from the
cavity.
4. To replace the
runners, hook the
wirework side runner
into the cavity, slide
back and press into
place.
Ensure the wirework runners are
firmly in position before replacing
the oven shelves.