Electrolux 70318-5 KG - Manual (Page 25)

25
Positioning
This appliance should only be installed at a location where the ambient
temperature corresponds to the climate classification indicated on the rat-
ing plate, which is located at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for each
climate classification:
SN +10°C to + 32°C
N +16°C to + 32°C
ST +18°C to + 38°C
T +18°C to + 43°C
For correct operation this appliance
must be located in a dry atmosphere,
away from heat sources, e.g. cookers,
radiators, boilers and direct sunlight.
You should also ensure that air can
circulate freely around the back and
the top of the cabinet. There should
be 100mm (4”) between the top of
the cabinet and any overhanging
kitchenfurniture. Alternatively allow
50mm (2”) between the top of the
cabinet and any overhanging
kitchen furniture and a gap of
25mm (1”) on either side of the
appliance.
Do not obstruct the space under-
neath. The back of the cabinet may
be placed close to the wall but must
not touch it. DO NOT install in places
with restricted ventilation.
Adjust the level of the appliance by
screwing out the adjustable foot, or
feet, at the bottom of the cabinet
using your fingers.
NP00
100 mm
10 mm 10 mm
D200
Rear spacers
Fit the rear spacers contained in
the appliance to ensure escape of
heat generated during operation.
Proceed in the sequence illustrat-
ed in figures.