Storage, Troubleshooting, Mains connection – Earlex COMBIPOWERVAC WD1200P User Manual

Page 6: After sales support

Advertising
background image

6

STORAgE

1. Clean out the collection bin as described on page 5.

2. Wrap the mains lead around the upper moulding and clip plug to lead using yellow clip,

as shown.

3. Locate the extension tubes on the taller posts on top of the unit, and the accessories on

the lower, angled posts. Alternatively you can locate the accessories on the tops of the
outriggers, as shown below.

TROUBLESHOOTINg

IF A PROBLEM OCCURS, SWITCH THE UNIT OFF IMMEDIATELY.

The unit does not turn on?
Check the unit is plugged in and switched on. Check the fuse in the plug and replace with a fuse of the same
rating - 13 amps and marked BS1362. If using an extension lead, check the fuse in this lead.

The motor operates but the unit fails to pick up?
Check if the cleaner requires emptying.
Check and clear any blockages within the system.
Check that the filter is clean and not damaged.

The motor makes a high pitched noise?
Check if the cleaner needs emptying and the float valve has operated.

Dust/grit is blowing out through the outlet?
Check the filter is fitted correctly and if heavy duty filter is used, check that it is fully pushed into position.

MAINS CONNECTION

The unit is a Class I appliance which means it is earthed for your protection.

If the supply cord is damaged it must be replaced by a genuine Earlex part, available through our Service
Department. It must be replaced by the manufacturer, its Service Agents or similarly qualified personnel in order to
avoid a hazard.

Please read the following safety instructions before use.

1. If the moulded plug is cut off from the mains lead then the plug must be disposed of safely.

NEVER

under any

circumstances insert such a plug into a 13 amp socket.

2.

NEVER

under any circumstances use the appliance or mains lead without the fuse cover fitted. This is the

cover on the base of the plug to hold the fuse in place.

3. If you lose the fuse cover then please contact our helpline on 01483 454666.

4. A replacement fuse must be rated at 13 amps. These must be manufactured and approved to BS1362.

IF IN ANY DOUBT, PLEASE CONTACT A QUALIFIED ELECTRICIAN.

AFTER SALES SUPPORT

A range of accessories and all spare parts are available from the Earlex Service Department who will be more than
happy to help.

PLEASE CONTACT OUR HELPLINE ON

Tel: 01483 454666
Fax: 01483 454548
Email: [email protected]

Opening Hours: Monday-Friday 08:30 - 17:00 (excluding Bank Holidays)

Advertising