Electrolux Built-In Dishwasher - Manual (Page 21)

22
Care & Cleaning
Care of Drain Air Gap
If a drain air gap was installed for your built-in dishwasher, check to make sure it is
clean so the dishwasher will drain properly. A drain air gap is usually mounted on
the sink at the countertop and can be inspected by removing the cover. This is not
part of your dishwasher and is not covered by warranty.
WINTERIZING
A dishwasher left in an unheated place should be protected from freezing. Have a
qualified person do the following:
To Disconnect Service:
1 Turn off electrical power to the dishwasher at the supply source by removing
fuses or tripping circuit breaker.
2 Shut off water supply.
3 Place a pan under the inlet valve. Disconnect water line from inlet valve and
drain into pan.
4 Disconnect drain line from pump and drain water into pan.
To Restore Service:
1 Reconnect the water, drain, and electrical power supply.
2 Turn on water and electrical power supply.
3 Fill both detergent cups and run dishwasher through a HEAVY WASH cycle.
NO NO NO NO NOTE TE TE TE TE
See Installation Instructions for more details.
NO NO NO NO NOTE TE TE TE TE
See Installation Instructions for more details.
CA CA CA CA CAUTION UTION UTION UTION UTION
Freezing temperatures may cause water lines to
rupture. Be sure all supply lines to and circulating
lines within dishwasher are protected. Failure to do
so could result in property damage.