THORENS TD 1600 Fully Manual Two-Speed Stereo Turntable (High Gloss Walnut) User Manual

Page 35

Advertising
background image

35

ELECTRICAL CONNECTIONS

Electrical connections

To power the turntable, connect the 16V output

of the power supply (Figure 12) to the input on

the right side of the terminal on the back of the

TD 1600 / TD 1601

using the enclosed cable

(Figure 13). The plugs should be locked in place

for safe operation with the knurled nuts.
The mains voltage can be switched depending

on the country at the bottom of the power supply

by a switch between 115V / 60 Hz and 230V / 50

Hz (Fig. 14).

Warning: before starting operation make sure

that the mains frequency and voltage are set

correctly. Otherwise there is a risk of damage

to the device.

Only then do connect the power supply to the

mains power socket with the included power

cable.
Below the connector on the back of the power

supply is the main electrical switch which turns

the power to the unit on and off. When the switch

is in position 0, the unit is completely disconnect-

ed from the mains.

Fig. 12

Fig. 13

Fig. 14

Advertising
This manual is related to the following products: