Elation Professional 36 - Manual (Page 26)

DESIGN LED 36 Pro™
©Elation Professional, Los Angeles Ca. 25 www.ElationLighting.com
11. LENS REPLACEMENT
The Design LED 36 Pro comes with a removable front cover that allows the lens assembly to
be changed out to achieve different beam angles.
The lens cover is held in place by four 5mm Allen screws. To access the lens kit, remove the
bard door assembly (if so attached) to access the four 5mm Allen screws, then loosen the
screws. The screws are held in by clips so they cannot be removed completely. Lift the outer
cover to access the lens kit. The lens kit is held in by four Phillips screws, remove these
screws to remove the lens kit. Replace the lens kit with the preferred option and reassemble
in reverse order. Be sure to align the rubber seal properly when reassembling.