Empire Comfort Systems LS-30FAS-1 - Manual (Page 4)

Page 4 15997-0-0903
PROPER INSTALLATION SEQUENCE:
LS-(18, 24, 30)FA(C,O,S) (Figure 1)
1. Place back left (#1) log onto left, rear pin on rear log support.
2. Place back right (#2) log onto right, rear pin on rear log support.
3. Place front left (#3) log onto two (2) left, front pins on burner
pan.
4. Place front right (#4) log onto two (2) right, front pins on burner
pan.
5. Place front (#5) log in front of burner pan.
6. Compare the completed log installation with the appropriate
photo from pages 5 through 7. Review previous steps to make
any necessary adjustments.
7. Log placement is completed.
Apply loose material (glowing embers) per appropriate Installation
Instructions and Owner's Manual. Replacement of loose material
(glowing embers) must be purchased from Empire Comfort
Systems, Inc. Application of excess loose material (glowing
embers) may adversely affect performance of the heater.
WARNING: All previously applied loose material must be
removed prior to reapplication.
Replacement Loose Material (glowing embers) Part Number
LS-18FA(C, O, S) 15999
LS-24FA(C, O, S) 15970
LS-30FA(C, O, S) 15970
Attention: Use the following procedure to connect ON/OFF
switch or remote receiver to VFSR burner assembly.
Remove ON/OFF switch from switch log assembly. Install ON/
OFF switch into switch bracket. Connect the 2-1/4" terminals onto
the TH and TH/TP terminals on valve. Place switch bracket to
right of the gas valve and burner assembly. When connecting to
remote receiver, cut off 1/4" terminals from wires attached to ON/
OFF switch. Strip wires back about 1/4". Connect stripped ends
into remote receiver.
LOG PLACEMENT
Before you begin: Do not, handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling logs,
wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are
not properly and firmly positioned in the appliance.
Refer to Figure 1 for the following warning.
Warning: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
Log Placement
LS-(18, 24, 30)FA(C,O,S) Logs
Figure 1
Attention: Do not use Figure 1 to order replacement logs. Refer
to Page 8 Parts List and Parts View to order logs for your
appropriate model number.
The following WARNING applies when log set is installed onto
an unvented gas burner assembly.
WARNING: This appliance is equipped for (natural or
propane) gas. Field conversion is not permitted.