Echo SB - Manual (Page 15)

15
SRM Models: If your trimmer-brushcutter requires
assembly before it can be used, you must make sure
the unit is properly configured for the type of cutting
attachment you will be using. Follow the instructions in
the Operator’s Manual provided with the unit. You must
install the required cutting attachment, debris shield,
handle, and any other protective devices needed, such
as a harness loop and safety harness. See SRM/PAS/
SB Set-Up Guide Page 17)
If your trimmer-brushcutter has been preassembled, you
must make sure the unit is properly configured for the
type of cutting you will be performing. If the unit is not
properly configured, you must first remove the incorrect
parts, and then install the correct parts, following the
instructions in the Operator’s Manual before using the
trimmer-brushcutter,
PAS/SB Models
Echo Pro Attachment Series (PAS) and Split-Boom
(SB) models are for use only with Echo PAS series
attachments, and must not be used with any other type
or brand of attachment. Select the desired PAS attach-
ment, and assemble the attachment to the powerhead
driveshaft using the coupler. Follow the safety and
operating instructions in the Operator’s Manual pro-
vided with the attachment, and General Safety Instruc-
tions in this Safety Manual.
SRM MODEL
Front
Handle
Debris Shield
PAS MODEL
Front
Handle
Barrier Bar
ASSEMBLY
GT MAXI-CUT BLADE/NYLON LINE HEAD SET-UP GUIDE
TO USE THESE
CUTTING
ATTACHMENTS* GT Series
Maxi-Cut Grass/Weed
Plastic Cutters
GT Dual Line
ECHOmatic
Line Head
GT Single Line
ECHOmatic
Line Head
2 Line GT
Rapid Loader
Line Head
Front Handle Loop Handle (STD)
Debris Shield Plastic Shield (STD)
Harness Not Required
Flat Washer Flat Washer
You
must
use
these
parts!
Mounting
Hardware* 3/8-24 R.H. Thread
Hex Locknut
Extra Hardware
Not Required
Extra Hardware
Not Required 3/8-24 R.H. Thread
Hex Locknut
Standard Cutting Line
Diameter
N/A .080 Diameter .080 Diameter .095 Diameter
* All required installation hardware provided with cutting attachment.