Enterasys Networks X-PEDITION E9.1.7.0 - Manual (Page 19)

ISSUES RESOLVED IN E9.1.7.0
10/02/03 P/N: 9038090-53 Subject to Change Without Notice Page: 19 of 31
F0615-J
ISSUES RESOLVED IN E9.1.7.0:
The following tables provide brief descriptions of the issues resolved in this release. E9.1.7.0 includes all issues
resolved in the E9.0.7.7 System Firmware Maintenance Release (see the E9.0.7.7 Release Notes for details).
10-Gigabit I.D.
Priority queue settings on the ER16-OS26-01 may cause the X-Pedition to experience ingress buffer
overflows. F4188
Entering the port show mc-vlan-encap all-ports command from the CLI erroneously displays the
ER16-OS26-01 system ports. F4319
Access Control List (ACL) I.D.
If a user applies multiple ACLs to a port, the acl show command may not display all of the ports in
the "Applied Port(s)" field. F4115
F4357
When using the acl-edit <acl_name> command to edit ACL data, users cannot remove all
commands associated with the ACL from the active configuration without rebooting the router. F4328
Advanced Routing Engine (ARE) I.D.
The ARE learns MAC addresses from all forwarded AppleTalk packets. The ARE should learn MAC
addresses from AARP Response packets only. F4142
The appletalk ping <address> command will fail if the target address belongs to an AppleTalk
interface on the same router that initiated the ping. F4147
Border Gateway Protocol (BGP) I.D.
Although the BGP Import policy filters routes correctly, these routes do not appear in the route table. F4347
Command Line Interface (CLI) I.D.
The system image command options use inconsistent naming schemes and may generate
messages that are unclear to users. Furthermore, default behavior varies between commands. F3609
If a serial console session times out after the X-Pedition prompts the operator for a reply to a
command they entered, the router may core the next time the console is activated. F4272
Negating or removing a command that contains a quoted string from the active configuration may
cause the router to core. F4299
When a user adds commands to the CLI through a cut-and-paste operation, the router may display
the “more” prompt before the CLI finishes processing the commands. F4325
When a user enters the copy active to scratchpad command from a CLI session, then closes the
session without issuing the logout or exit command, future CLI sessions will hang when attempting
to perform any operations that involve accessing the active configuration. F4387
Users cannot select the unicast or multicast options with the ip-router policy import source and
ip-router policy aggr-gen destination commands. F4448
Distance Vector Multicast Protocol (DVMRP) I.D.
Clients attached to a DVMRP-enabled interface that is also an 802.2Q trunk port may see multicast
traffic requested by a client in a different VLAN that is also part of that trunk port. F4316