Emerson CF711PBOO - Manual (Page 5)

5
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
To avoid fire or shock, do not pinch wires between
the hanger ball/downrod assembly and hanger
bracket.
WARNING !
WARNING
!
Installing The
Hanger Bracket
1. Unscrew (but do not remove) the two mounting
screws in the outlet box (Figure 5). Position the
hanger bracket on the outlet box so that the T-slots
in the hanger bracket are aligned with the outlet
box screws.
The fan must be hung with at least 7' of clearance
from floor to blades (Figure 4).
WARNING
!
FLOOR
7'
MIN.
Figure 4
HANGER BRACKET
HOOK
SECURELY
TIGHTEN
SCREWS
Figure 6
HANGER
BRACKET
LOOSEN TWO
SCREWS (SUPPLIED
WITH OUTLET BOX)
OUTLET BOX
SLIDE THE HANGER
BRACKET ONTO
THE OUTLET BOX
SCREWS, THROUGH
THE T-SLOT
T-SLOT
Figure 5
Hanger bracket must seat firmly against outlet box. If
the outlet box is recessed, use leveling washers
between the hanger bracket and the outlet box until
the bracket is flush with the ceiling. If bracket and/or
outlet box are not securely attached, the fan could
wobble or fall.
WARNING !
Hanging The Ceiling Fan
(Standard Method Using
Hanger Ball/Downrod)
1. Carefully lift the fan assembly and seat the hanger
ball in the hanger bracket (Figure 7). The tab on
the hanger bracket must seat in the groove in the
hanger ball.
NOTE: The hanger bracket must be mounted
flush with the ceiling in order for the ceiling cover
to install properly. If necessary, use leveling
washers (not supplied) between the outlet box
and the hanger bracket.
2. Slide the hanger bracket onto the outlet box
screws. Center the bracket over the outlet box and
then securely tighten the screws (Figure 6).
The outlet box and joist must be securely mounted and
capable of supporting at least 50 lbs. Use only a U.L.
outlet box listed as “Acceptable for Fan Support”.
WARNING
!
To reduce the risk of fire, electrical shock, or personal
injury, mount fan to outlet box marked “Acceptable for
Fan Support”, and use screws supplied with outlet box.
Most outlet boxes commonly used for support of light
fixtures are not acceptable for fan support and may
need to be replaced. Consult a qualified electrician if
in doubt.
WARNING
!