Electrolux EW 1280F - Manual (Page 11)

11
10 SKIP RESET button
This button performs two functions:
- Clears the memory
- Selects special programmes
At the end of every programme the RESET button
must be pressed once or repeatedly to clear the
programme memory. This will be confirmed by three
dashes, flashing in the display.
If the previous programme is not cleared, the display
will show a “0” flashing and an audible signal will
sound, when you switch the machine on.
Selecting a special programme:
A wash programme must be selected in the normal
way.
(START button not pressed)
The SKIP button is then used to cancel or advance
the programme to the required phase.
The SKIP button can only operate when the
programme is in pause. The relevant pilot light
blinks.
A normal wash cycle consists of the following
phases, Wash - Rinses - Spin and is confirmed by
the illumination of the corresponding LED,s.
Prewash
Wash
Rinses
Spin
Drain
Start/Pause
To select rinses & spin, the programme must be
paused (START/PAUSE button depressed), now
press the SKIP button once, the wash LED goes out.
To select spin only, now press the SKIP button
twice.
The wash & rinses LED,s go out.
To select Drain, now press the SKIP button three
times, the wash - rinses - spin LED,s go out and
the Drain LED remains lit.
Prewash
Wash
Rinses
Spin
Drain
Prewash
Wash
Rinses
Spin
Drain
Prewash
Wash
Rinses
Spin
Drain
132990380.qxd 01/04/2004 13:35 Pagina 11 (Nero/Process Black pellicola)