Emerson CKS2000N - Manual (Page 9)

8
LISTENING TO THE RADIO
• Set the Band selector to the desired band, AM or FM.
• Set the Volume control to a low setting.
• Press the Radio On/Off button to turn the radio ‘On’.
The radio dial pointer wil light.
• Select your desired station with the Tuning control.
• Adjust the Volume control to the desired setting.
• When you are finished listening, press the Radio On/Off button to turn the radio
‘Off’.
The radio dial pointer light goes off.
ANTENNA INFORMATION
AM - The AM bar antenna is inside the cabinet. If AM reception is weak, change
the position of cabinet until the internal antenna picks up the strongest
signal.
FM - The FM antenna is built in to the AC power cord. If FM reception is weak
try varying the position and direction of the power cord until you find the
strongest signal.
WAKE TO RADIO
1. Turn the radio ‘On’ and select the band, station, and volume level that you
wish to hear when the alarm comes on, then turn the radio ‘Off’ again.
2. Reconfirm the wake up time and alarm mode settings for the alarm you are
using, Alarm 1, Alarm 2, or both alarms.
3. Set the Alarm selector switch for one or both alarms to the ‘Radio’ position.
The appropriate Alarm 1 and/or Alarm 2 indicators will light up to confirm that
the alarms are set.
4. At the selected wake up time the radio will turn ‘On’. It will play for one hour
and then shut off automatically.
5. To stop the radio sooner, press either the appropriate Alarm 1 or Alarm 2
button, or press the Radio On/Off button. The radio will stop but the alarm
remains set and will turn the radio on again at the same time on the following
day (depending on the Alarm Mode setting).
6. If you do not want the alarm to turn the radio on the following day, set the
appropriate Alarm selector to the ‘Off’ position.