Extron electronic RGB 580xi - Manual (Page 12)

RGB 580xi • Installation and Setup RGB 580xi • Installation and Setup
Installation and Setup, cont’d
2-13
DDSP disables the horizontal shifting control.
5 Input select button — Pressing this button results in contact
closure between pins A and B of the contact closure control
connector on the front panel of the RGB 580xi.
Cabling the AAP Device Rear Connectors
Extron’s various AAP devices for the RGB 580xi may come with
several rear connectors that may require cabling.
Although the VGA and control cable/LED assembly
comes prewired to the captive screw connectors, any
subsequent cable assembly replacement will require the
following cabling instructions.
To cable the captive screw connectors, refer to the following
diagrams and orient the wires according to the view angle of
the captive screws. When using Extron’s VGA and control cable
assembly (see appendix A, “Optional RGB 580xi AAP Extension
Cables” for part numbers), refer to the color of each wire for
signal identification.
Example of AAP device rear connectors
1 Control connector (J4) — Insert wires into and tighten the
screws on the 3.5 mm, 5-pole captive screw connector. This
connector is used for contact closure and horizontal shifting
signals. Wire the connector as shown in the following
illustration.
H. SHIFT
COMPUTER
RGB 580xi SI AAP
INPUT
SELECT
AUDIO
1
3
2
Red
Black
White Yellow
Pink
Green
Gray
Lt. Blue
Purple
2-12
2. Follow steps 3 through 8 in the Installation Overview
section of this chapter.
AAP Device Features
1 Power/signal LED — This LED lights
• amber to indicate that the AAP device is receiving power.
• green to indicate that an active sync signal is present at the
input and that the AAP device is receiving power.
The LED flashes green whenever the minimum and
maximum limits of the horizontal shift control (H. shift)
have been reached.
2 RGB video input connector — Attach a cable from the
computer source to this 15-pin HD female connector.
3 Audio input connector — Plug a 3.5 mm stereo plug into this
jack for unbalanced audio input. Wire the male plug as shown
below.
Tip (L) Sleeve (GND)
Tip (L)
Ring (R)
Sleeve (GND)
4 Horizontal shift control knob (H. shift) — While viewing the
displayed image, rotate this control to move the image to the
right or left on the screen. The power/signal LED flashes green
whenever the minimum and maximum limits of this control are
reached.
SHIFT
COMPUTER IN
SELECT AUDIO IN
RGB 580xi
SHIFT
COMPUTER IN
AUDIO IN
RGB 580xi
COMPUTER IN
AUDIO IN
RGB 580xi
1 1
1 5 2
2
3
3 3
4
4
RGB 580xi AAP RGB 580xi S AAP
RGB 580xi SI AAP
2