Extron Electronics WP CTL D User Manual

Wp ctl d installation guide, Wp ctl d installation guide, cont’d, Gs ir g rx tx serial

Advertising
background image

1.

Using a mud ring or a junction box as a guide, mark the holes and cut out the

material within the marked area.

N If installing a junction box, allow enough depth for

the wall plate and cables.
The box should be at least 2.0” (5.1 cm) deep to
accommodate the connectors, plate, and cables.

2

. Either

• Insert the mud ring into the opening, rotate

the dog legs, and secure with the screws provided,

or
Insert the wall box and secure with 10-penny nails

or screws.

3.

Run the RS-232 and IR signal cables behind the wall

and thread them through the mud ring or wall box.

N

Extron recommends using a good quality, low

capacitance, shielded cable such as an Extron
CTL or SPL Control cable.

Decora

Faceplate

Extron
WP CTL D

Wall

Wall Mounting

Bracket

G

S

IR

G
Rx
Tx

Serial

WP CTL D Installation Guide

The Extron WP CTL D is a Decora style 1-gang wall plate which passes RS-232 control signals

from a computer or control system, and IR signals from an IR source.

Install it directly into the wall using a mud ring, or in a 1-gang junction box (not supplied),

following the steps below.

4.

Connect the IR cable to the rear panel IR

connector by inserting the signal wire into

the hole marked "S" , and the ground wire

into the hole marked "G" (see inset, step 4).

N

The recommended driving distance from

an MLC controller is 100 feet.

5.

Connect the RS-232 cable to the rear panel RS-232

connector by inserting the ground wire into the hole

marked "G", the transmit wire into the hole marked

"Tx", and the receive wire into the hole marked

"Rx" (see inset, step 5).

6

. Mount the device into the mud ring or wall box.

7

. Attach the supplied Decora faceplate.

N

If applicable, repeat steps 1-7 to install additional wall plates.

8

. Connect the RS-232 control device and/or IR input device to the front of the WP CTL D.

Extron

USA - West

Headquarters

+800.633.9876

Inside USA / Canada Only

+1.714.491.1500

+1.714.491.1517 FAX

Extron

USA - East

+800.633.9876

Inside USA / Canada Only

+1.919.863.1794

+1.919.863.1797 FAX

Extron

Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron

Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400

+65.6383.4664 FAX

Extron

Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron

China

+400.883.1568

Inside China Only

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron

Dubai

+971.4.2991800

+971.4.2991880 FAX

68-1618-01

Rev B 08 08

WP CTL D Installation Guide, cont’d

Step 5

Step 4

G

Tx

Rx

WP CTL D

IR Out

White striped wire

S = Signal (IR)

G = Ground

G S

IR Emitter

100'

(30.5 m)

Advertising
This manual is related to the following products: