Eclipse - Fujitsu Ten CD5100 - Manual (Page 9)

- 9 -
Español
Français
Italiano
Nederlands
Svenska
English
System connection e System connection e xample xample
• • Never cut the insulation on the power wire or use it to power any other equipment. If the rated current
capacity of the power wire is exceeded, fire and electric shocks may result.
• • The wires should be secured with tape or a similar securing method to prevent any obstructions while
driving. If they get wound or entangled around components such as the steering wheel, shifting lever,
or brake pedal, accidents may result.
• • If removing the end of the wire to connect to another wire, be sure to wrap PVC tape or a similar wire
insulating method around the connection to insulate it. If the connection is not insulated, fire or
accidents may result.
• • Install and connect all of the peripheral equipment before connecting them to the main unit.
• • Do not remove any of the protective caps (RCA, etc.) unless in use.
• • Be sure to wrap the connection wires with tape (PVC tape) to insulate them.
• • Adjust the external amplifier’s input level.
Tip
1) CD7100 (CD5100 or CD3100) + iPC106 + CH3083 + MEI100 + GPS105 + Power Amplifer
13P
iPC106
(sold separately)
2P
13P
INTERCONNECTING WIRES
(supplied with iPC106)
MEI100 : The MEI100 cannot be connected to the CD5100.
(sold separately)
TO SIGNAL INPUT OF AUXLIARY
POWER AMPLIFIER
L SIDE
TO GROUND
TO ACC (Power Supply)
Red
TO HEAD LIGHT SWITCH
(Illumination (+) )
Orange/White
TO POWER ANTENNA
RELAY (Supply)
Blue
Blue/White
Yellow
Black
16P
To iPod
MAIN UNIT 1
INTERCONNECTING WIRES
(Power and speaker connector)
2
*
TO STEERING REMOTE CONTROL
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Brown
Brown/Black
NO CONNECTION (Do not remove cap)
CH3083
(sold separately)
INTERCONNECTING
WIRES
(supplied with CH3083)
TO GROUND
13P
2P
NO CONNECTION
(Do not remove cap)
NO CONNECTION
(Do not remove cap)
TO GROUND
TO BATTERY+12V
(Permanent Supply)
TO BATTERY+12V
(Permanent Supply)
13P
TO TURN-ON WIRE OF
EXTERNAL EQUIPMENT
(Supply)
INSULATE EACH WIRE WITH NONE
CONDUCTING TAPE SUCH AS
PLASTIC TAPE OR ANOTHER
INSULATING METHOD
INSULATE EACH WIRE WITH NONE
CONDUCTING TAPE SUCH AS
PLASTIC TAPE OR ANOTHER
INSULATING METHOD
TO USB DEVICE
GPS105
(sold separately)
GPS ANTENNA
(supplied with GPS105)
INTERCONNECTING WIRES
(supplied with iPC106)
INTERCONNECTING WIRES
(supplied with iPC106)
8P
INTERCONNECTING WIRES
(supplied with GPS105)
• • THE CD3100 IS NOT EQUIPPED WITH THE CONNECTORS INDICATED BY
*
.
*
*