Escort 9500CI - Manual (Page 15)

26 27
Problem
PASSPORT beeps briefly at the
same location every day, but no
radar source is in sight.
PASSPORT does not seem
sensitive to radar or laser.
PASSPORT did not alert when a
police car was in view.
PASSPORT only beeped twice
during a radar encounter.
PASSPORT’s audible alerts are
less loud after the first few
alerts.
PASSPORT’s power-on
sequence reoccurs while you
are driving.
Your 14-year old son has
changed all of your Preferences.
PASSPORT will not turn on.
Solution
• An X or K-band motion sensor or intrusion alarm is
located within range of your route. You can manually
lock this out using TrueLock, or allow AutoLearn to
do it over time.
• PASSPORT may be in Auto or AutoNox mode.
• VASCAR, (Visual Average Speed Computer And
Recorder) a stopwatch method of speed detection,
may be in use.
• This is normal. Full alerts are minimized when
traveling below 25 mph.
• PASSPORT is in AutoMute Mode. See page 4 for
details.
• A loose power connection can cause PASSPORT to
be briefly disconnected, and will retrigger the power-
on sequence.
• You can return all of the Preferences to their factory
defaults by holding down the SENS and VOL buttons
while you turn PASSPORT on.
• Check that the PWR button is ON.
• Check that vehicle ignition is ON.
• Check all connections.
Explanation of Displays
Lsr R
N/A
Check
Receiver
Wiring
ANX
H
PilotHWY
WorkZone
Caution
X|
or K|
or
KA|
etc.
Receiver
Error
GPS N/A
Troubleshooting
There is a problem with the rear laser receiver (it could be an
unplugged connection, damaged wiring, or a problem within the rear
laser unit itself).
There is a problem with the front receiver (it could be an unplugged
connection, damaged wiring, or a problem within the front receiver
itself). PASSPORT will continue to display this message, and will not
operate until the problem has been repaired.
Sensitivity control is in Auto No X-band. (page 7)
Sensitivity control is in Highway mode. (page 14)
One of the many options in Preferences (pages 12-16)
One of the many Safety Radar messages (pages 24-25)
PASSPORT has detected a Safety Radar Signal, but the signal isn’t yet
strong enough to decode the specific safety message (pages 24-25)
PASSPORT has been programmed in the ExpertMeter Mode (page 11)
PASSPORT has failed to calibrate. Contact your Dealer for repair.
Not able to receiver GPS signal. Check GPS antenna connection.