Euro-Pro SELECT EP923H - Manual (Page 10)

Concentrator
Attach the concentrator to the
handgrip or to the extension
tubes. Then attach the detail
brushes To the concentrator.
To use: Connect the tile
squeegee to the hand
grip or use with
extension tube for
hard to reach surfaces.
Apply steam abundantly, rub with the
soft spongy edge, then remove excess
water and dirt with the glass wiping
edge.
IMPORTANT: When cleaning
windows, always avoid any sudden
changes in temperature to prevent glass
breakage or cracks.
Nylon Bristle Brush
It is best for cleaning grout in-between
the tiles, ceramic and marble.
To use: Attach the nylon bristle
brush on to the end of the
concentrator, which then may
be used directly on the hand
grip or with extension tubes
Wall Paper Scraper
Note: The Wall Paper Scraper
is packaged already attached
to the concentrator.
To attach the concentrator to
the flexible hose, push it in
until the locking button on the hose clicks
in place with the hole on the concentrator
If the wall paper scraper is not attached to
the concentrator, screw it on to the
concentrator. (Fig. 14)
Note: The wall paper
concentrator
cannot be
used without
the wall paper
scraper.
Fig. 14
Brass Bristle Brush
Use the brass bristle brush to clean
ovens and hard metal surfaces.
To use: Attach the brass bristle
brush on to the end of the
concentrator, which then may be used
directly on the hand grip or with
extension tubes
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
100% white terry cloth towel can be fitted
on this brush, so as to absorb the dirt and
protect delicate surfaces.
Important: Please note that bristles
may break through thin towels. We
recommend that two (2) towels, laid one
on top of the other be used. This will
ensure that the brush bristles do not
break through and that the towels will be
sufficiently absorbent and retain as much
dirt as possible.
Very Important : When installing the
towels to the triangular brush, ensure that
the towels do not cover the front and the
back of the brush. (See Fig. 13)
Fig. 10
1. Prepare white terry cloth
towel:
size 8” x 17” as
shown in Fig. 10.
2. Place the brush on
top of the towel.
4. Place the corner
under the cloth
holder. (Fig. 12)
Fig. 11
3. Fold the towel
as shown in
Fig. 11
Fig. 12
5. Fold the other side
of the towel in the
same way and
place the corner
under the cloth
holder. (Fig. 13)
Fig. 13
Attaching a Towel to the
Triangular Brush
Fig. 17 Locking
Button VERY IMPORTANT: Use only
the soap that has been supplied
with your steam cleaner. Use of any
other type of detergent soaps may
damage the pump mechanism and the
feed system of the injector. Regular
detergent soaps SHOULD NEVER BE
USED with this injector.
Filling the Soap Injector
To Fill Soap Injector:
1. Remove the filler cap from the soap
injector.
2. Hold the soap
injector in your
hand and place the
small funnel into
the opening.
(Fig. 15)
3. Pour soap into the
soap injector.
Do NOT overfill. Do NOT dilute the
soap solution. Do NOT add water. Do
NOT mix with any other household
cleaner.
4. Replace the filler cap onto the soap
injector.
5. Attach the soap injector to the hand
grip. (Fig. 16) Make sure that the
locking button snaps in place.
(Fig. 17)
6. The soap injector may be used with
the concentrator or the soap
accessories. (Fig. 18)
7. To use the soap injector, press on
the pump button for soap to be mixed
with the steam. (Fig. 18)
8. When you have finished using the
soap injector, remove it from the
hose and attach the accessories that
were used to the hose so that you can
remove any excess soap from them or
run them under warm running water to
clean.
Fig. 15
Fig. 16
Fig. 18 Pump
Button
Locking
Button
Or
Note: We recommend using the soap
solution on hard surfaces such as
bathroom tile, bathroom fixtures,
counters. We do NOT recommend
using the soap on carpeting, upholstery
or hardwood floors.
WARNING: Do NOT use on
pets, plants or people.
IMPORTANT: Always rinse the small
funnel after using it to fill the soap
injector. Never use the small funnel
to fill the steam cleaner boiler.
Using the Soap Injector
We recommend using the soap injector
with the soap accessory adapter or the
concentrator with the bristle brushes. Do
not use the soap injector with the
steam pocket. You can use the
concentrator to apply the soap.
1. Use the steam to moisten and heat
up the stain that you wish to remove.
2. Spray the soap onto the surface with
the stain.
3. Let the soap stay on the stain for 10
to 15 seconds. Then using a brush,
scrubbing pad or sponge, scrub the
stain.
4. Then using the steam, scrub the stain
some more and then wipe it clean
with a towel.
5. For stubborn stains, repeat steps
1 to 4 one more time. Attaching the Accessories to the
Flexible Steam Hose
Dual Edge Glass & Tile Squeegee
This attachment is very useful for
cleaning large windows, plastic material,
ceramic, tiled or marble surfaces.
8 9