Brush roll belt, How to replace a worn belt – Eureka 600 User Manual

Page 9

Advertising
background image

Brush Roll Belt

The brush roll belt on the upright vacuum cleaner drives the brush to agitate, sweep,
and comb the carpet nap. The belt should be checked regularly to be sure it is in good
condition. Replace the belt if it is stretching, cracking, or slipping. Cut away any hair or
thread wound around the brush roll or the belt pulley because the buildup could cause
the belt to rotate unevenly.

How To Replace A Worn Belt

NOTE: Turn off the switch and unplug the electrical cord before replacing belt.

Belt pulleys can become hot during normal use. To prevent injury, avoid
touching the belt pulley when servicing the drive belt.

IMPORTANT: Improper installation of the brush roll or brush roll belt could cause

carpet or cleaner damage.

Look for the

symbol.

9

Ask for GENUINE EUREKA
replacement belts No. 52100.

GENUINE

EUREKA PRODUCT

1

1

1. Release cam locks.

Belt
Guide

Check for brush wear, see Brush Roll
instructions.

3. Place new belt around brush roll.

4. Align brush roll pulley with belt

guide.

Brush Roll Pulley

Motor
Pulley

2

2. Pull up on belt to rotate it off the

motor pulley. Lift up on brush roll
and remove worn belt.

6

5

5. Place rubber end cap covers over

both end caps (flat side against end
cap). Align holes and secure. Then,
slant brush roll forward so end
caps are in line with slots in cleaner
base.

6. Push brush roll into base

9

9

8

8

8. Place slots of bottom plate over

tabs of cleaner base.

9. Seat and secure cam locks

7

7. Place lower side of belt into belt

guide and pull to stretch the belt
around the left side of the motor
pulley. Rotate pulley to secure
belt into groove.

Advertising