Changing & cleaning the dust cup filter – Euro-Pro EP033 User Manual
Page 3
HOW TO OPERATE YOUR HAND VACUUM
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE REASON
POSSIBLE SOLUTION
HAND VACUUM WILL
NOT OPERATE
1. Power cord not firmly
plugged into outlet.
2. No power in wall outlet.
3. Needs
servicing.
1. Plug unit in firmly.
2. Check
fuse
or
breaker.
Replace fuse/reset
breaker.
Call 514-842-8691
HAND VACUUM WILL
NOT PICK-UP OR
SUCTION POWER IS
WEAK
1. Dust cup filter is full.
2. Unit
clogged.
3. Dust cup filter needs
cleaning.
1. Empty dust cup filter –
(see page 4).
2. Turn unit off and unplug
from wall outlet. Remove
dust cup filter and check
for object(s) in air duct
and remove.
3. Clean or replace dust cup
filter. (see page 4).
DUST ESCAPING
FROM HAND
VACUUM
1. Dust cup filter is full.
2. Dust cup filter is not
installed correctly.
3. Puncture/hole
in
dust
cup
filter.
1. Empty dust cup filter.
2. Review dust cup filter
instructions. (see page 4)
3. Replace dust cup filter.
(see page 4)
HAND VACUUM HOSE
OR BRUSHES WILL
NOT PICK-UP
1. Hose
clogged.
2. Dust cup filter is full.
1. Remove
hose
and/or
bushes. Remove
obstruction from hose.
2. Empty and clean dust cup
filter.
1. Hold the hand vacuum firmly with your hand on the Handle (4).
2. Push the On/Off Power Switch (2) to “On” position.
3. Start vacuuming.
CAUTION:
The Hand Vacuum is a very powerful unit. Make sure
that you hold it firmly, otherwise it can slip out of your
hand and cause injury.
CHANGING & CLEANING THE DUST CUP FILTER
Warning: Always unplug from electrical outlet before opening the Dust Cup
(container) (10).
1. To open the Dust Cup (container) (10), push button (1) and pull out the Dust
Cup (container ) (10), (fig. 1).
2. Pull out the Dust Cup Filter (8), (fig. 2).
3. Empty the dust from the Dust Cup Filter (8).
4. Rinse the Dust Cup Filter (8) in cold water, and then wait until it dries up
before replacing it into the Dust Cup (container) (10).
5. Place the Dust Cup Filter (8) carefully into the Dust Cup (container) (10).
6. Attach the Dust Cup (container) (10) to the Hand Vacuum.
Fig. 1
Fig. 2
CAUTION:
The suction hole (3) must be open, free of any obstructions
at all times. Otherwise, the motor will overheat and could
get damaged.
4
5