EVGA Classified SR-2 - Manual (Page 37)

EVGA Classified SR-2 Motherboard
37
Jumper Settings
PCI-E Disable Jumper
For the ease of troubleshooting multiple graphics cards or testing an
individual graphics card’s overclocking, EVGA has implemented seven
jumpers you can use to disable individual PCI-E slots. You don’t need to
remove any of your graphics cards but simply disable the slot the particular
card is in.
You see the location of the 7 jumpers in the above diagram. They are
located right above the 24-pin ATX Connector. In default shipping
configurations, all slots are enabled with the jumpers in the left position.
From top to bottom, PCI-E slots 1, 3, 5, 7, 2, 4, 6 respectively. To disable a
PCI-E lot, move the jumper over to the right position.
Example: Remove the Jumper cap of JPE2, PCI-E Slot 2 is disabled while
the rest are enabled. The PCI-E Disable Function can also be extended
onto the EVGA Control Panel (ECP).
Do this when the PC is turned off, NOT while it is running!
JPE1
JPE3
JPE5
JPE7
JPE2
JPE4
JPE6