H-300+m, Product specifications, Flow rate – Everpure H-300+M User Manual

Page 2: Temperature, Pressure, Capacity, Everpure warranty, Features

Advertising
background image

product specifications

Health Claim Performance Certified by NSF/ANSI*

This system has been tested according to NSF/ANSI 42 and 53 for the reduction of the substances listed below. The concentration of the
indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving
the system, as specified in NSF/ANSI 42 and 53.

Influent Challenge Max. Permissible Product

Reduction

Minimum

Average

Substance

Concentration

Water Concentration

Requirements

Reduction

Reduction

Standard 42-
Aesthetic Effects

Chlorine

2.0 mg ± 10%

>_ 50%

96.8%

Particulate, Class I
Particles 0.5 - 1 µm

at least 10,000 particles/mL

>_ 85%

99.2%

Standard 53-
Health Effects

Asbestos

10

7

to 10

8

fibers/L > 10 micrometers in length

99%

99.86%

99.86%

Cyst

Minimum 50,000/L

99.95%

99.99%

99.99%

Lead 6.5

0.15 mg/L ± 10%

0.010 mg/L

99.4%

98.8%

Lead 8.5

0.15 mg/L ± 10%

0.010 mg/L

97.3%

98.7%

Chloroform

0.310 mg/L

0.015 mg/L

95.7%

98.6%

(VOC surrogate chemical)
*Tested using flow rate=0.5gpm; pressure=60 psig; pH=7.5 ±0.5; temp.=20˚C ±2.5ºC

Everpure, Micro-Pure and the silver canister color are registered trademarks of Everpure, LLC © 2008

®

®

Chemical Reduction

>

Taste and Odor

>

Chlorine Taste and Odor

Mechanical Filtration

>

Particulate Reduction: Class I

Chemical Reduction

>

VOC

Mechanical Filtration

>

Cyst

>

Asbestos

System Tested and Certified by NSF International against NSF/ANSI

Standard 42 and 53 for the reduction of:

Standard No. 42 Aesthetic Effect:

Standard No. 53 Health Effects:

>

Lead

H-300+M

Commercial grade drinking water system

with Performance Indication Device

This drinking water system must be

maintained according to the

manufacturer's instructions, including

replacement of filter cartridges. The

substances reduced or removed by this

system are not necessarily in your water.

Read the performance data sheet.

flow rate

Controlled at 0.5 gal./min. (1.9 L/min.)

temperature

35-100 °F (2-38 °C) cold water use only

pressure

10-125 psi. (0.7-8.6 bar), non-shock

capacity

500 gal. (1,892 L)

everpure warranty

Everpure Drinking Water Systems are

warranted to be free of defects for a full

twelve (12) months after purchase. A

detailed warranty statement is provided

with each system.

H-300+M System – Part No. EV9270-79
H-300+M Cartridge – Part No. EV9270-81

Features:

> Finely polishes treated water to premium quality for drinking and cooking.
> Reduces dirt, rust, asbestos fibers, and other particulates such as oxidized iron, manganese, and

sulfides.

> Reduces chlorine taste and odor.
> Reduces parasitic protozoan cysts such as Giardia, Entamoeba, and Cryptosporidium.
> Controls even extreme levels of common “off” tastes and odors, including those which are earthy,

moldy, and fishy.

> Reduces lead to below the Federal Action Level.
> Effectively reduces Volatile Organic Chemicals (VOCs).
> KDF Media reduces limescale build-up in water-using appliances — as tested by KDF® Fluid

Treatment, Inc.

> KDF Media provides bacteriostatic control — as tested by KDF® Fluid Treatment, Inc.
> Equipped with a Performance Indication Device (PID), which operates on two standard “AA”

batteries.

General Installation/Operation/Maintenance Requirements:

> It is recommended that before purchasing a water treatment unit, you have your water tested to

determine your actual treatment needs.

> Space required: 5 x 5 x 22 in. (13 x 13 x 56 cm) including 2-1/2 inches of clear space under unit for

cartridge change.

> Install vertically with cartridge hanging down.
> Replace cartridges when capacity is reached, or when flow becomes too slow, but at least annually.
> The monitor (PID) provides real time indication of the H-300+M’s capacity. The monitor’s built-in LED

lights illuminate to convey the status of a capacity of a cartridge, keeping track of time while
recording the amount of gallons the system has filtered. The appropriate lights activate only when
water is on with the exception of the red light, which will stay on until the cartridge and batteries are
replaced, resetting the system. Blinking green – OK, blinking yellow – replace soon, constant red –
change filter.

> Do not use with water that is microbiologically unsafe or of unknown quality without adequate

disinfection before or after the system. Systems certified for cyst reduction may be used on
disinfected water that may contain filterable cysts.

> A separate drinking water faucet is required.

Advertising