Electrolux 74800 - Manual (Page 28)

28
Where to install
Important! The washing machine must not be operated in a room
where there is a danger of frost. There is a risk of frost damage or ad-
verse effect on the perfomance of the machine. Frost damage is not
covered under the warranty.
• The surface on which the appliance is to be installed must be firm
and level. Do not install the appliance on carpeted floors or soft floor
coverings.
• The surface on which the appliance is to be installed must be clean
and dry and free from grease, so that the appliance does not slide.
• If the location in which the appliance is to be installed is fitted with
small-format tiles, put a rubber mat (available in the shops) under
the appliance.
If the appliance is to stand on a floor which moves, e.g. a suspend-
ed wooden floor:
Place the appliance in an area as close as possible to a corner of the
room.
1. Screw a water-resistant wooden board (at least 15 mm thick) onto at
least 2 of the floor joists.
Making the appliance level
The four feet of the appliance are
pre-adjusted.
Large degrees of unevenness can be
compensated for by adjusting the
four feet of the appliance.
Use the special spanner supplied to
do this.
Important: Do not use pieces of
wood, cardboard or such like to level
out small degrees of unevenness in
the floor. Adjust the adjustable feet
instead.
Electrical Connection
Any electrical work required to install this appliance should be carried
out by a qualified electrician or competent person.