EverFocus EZ550 - Manual (Page 28)

C H A P T E R 3 O S D M E N U A N D C O N F I G U R A T I O N
26
3.3 OSD Menu Setup
Please make sure control key selection switch is at OSD position.
Note: Unlike setting Camera ID that requires you to press 3 seconds, OSD menu only
requires one click (less than 1 second) and you should see the following menu.
3.3.1 LENS
1. When the SETUP menu is displayed on the screen, please direct the arrow to point to
“LENS” by turning the mini-joystick UP (c) or DOWN (d). Press the mini-joystick
to adjust IRIS level (the higher is brighter). In most cases, you don’t need to adjust this,
since Lens is Auto Iris supported.
NOTE:
Since DC lens is a built-in lens for EZ550 camera, it does not support Manual lens, please
do not select lens as Manual mode, it disables sens-up and may cause malfunction of lens.
2. Please press the mini-joystick for saving setting and return to the previous menu.
3.3.2 SHUTTER
1. When the SETUP menu is displayed on the screen, please direct the arrow to point to
“SHUTTER” by turning the mini-joystick DOWN (d).
2. Select the shutter mode by turning the mini-joystick LEFT (e) or RIGHT (f).
Three modes are available. FLK, ESC and Manual.
SETUP
> LENS DC
<┘
SHUTTER ___
WHITE BAL. ATW
BACKLIGHT OFF
AGC MIDDLE
DNR LOW
SENS-UP AUTO
<┘
SPECIAL <┘
EXIT
LENS
LEVEL |+++++++++| 25
SETUP
> LENS DC
<┘
SHUTTER ___
WHITE BAL. ATW
BACKLIGHT OFF
AGC MIDDLE
DNR LOW
SENS-UP AUTO
<┘
SPECIAL <┘
EXIT