Essick Air H10 400 - Manual (Page 3)

Important Filling
Information
1) Your humidifier is equipped with one water bottle. When both the water bottle and reser-
voir have emptied, the humidifier fan will automatically shut off, but will start again auto-
matically when the water bottle and reservoir are refilled.
2) When the bottle is being filled for the first time and the wick is still dry, it will take
approximately 20 minutes to drain the bottle into the reservoir. After the bottle has emp-
tied into the reservoir, it should be refilled again to obtain maximum running time.
3) When refilling the bottle and the wick is still wet, it will take approximately 12 minutes
to refill the reservoir. At this time, you should refill the bottle for maximum running time.
4) Dry air is drawn into the humidifier through the back and moisturized as it passes
through the evaporative wick. It is then fanned out into the room.
1) Water bottle
2) Chassis/Power Pack
(motor and fan assembly)
3) Evaporative wick
4) Water reservoir
5) Dry room air intake
6) Moist air output
5) Locate your humidifier on an inside wall near an electrical outlet. The humidifier should
be at least 4” away from the wall for best results. Do not position the unit directly in
front of a hot air duct or radiator.
Assembly and Operation
1) Remove the two polyfoam inserts from the top of the humidifier.
2) Lift off the black water bottle cover (left-hand side). Remove the water bottle, lift off the
chassis/power pack and then remove the humidifier cabinet from the carton.
3) Remove the evaporative wick, float assembly (black rod with white float), and all of the
remaining packaging materials from the cabinet. Check to see that you have all of the
following items removed from the boxed accessory kit and cabinet before discarding the
packaging:
• Filler hose
• Bacteria treatment
• Caster kit • Water bottle with cap.
• Optional AirCare ® filter. (May be purchased as an accessory.)
6
2
1
5 5 3
4