Emerson LD200EM8 - Manual (Page 20)

20
EN
O
PTIONAL SETTING
Channel Add/Delete
The channel add/delete function lets you add the channel that was not
added by the auto channel scan due to the reception status at the initial
setting. You can also delete the unnecessary channels.
1
Press [SETUP] to display the main menu.
2
Use [Cursor K/L] to select “CHANNEL SETUP”, then
press [ENTER].
e.g.) digital TV mode
or
- TV SETUP -
CHANNEL SETUP
V-CHIP SETUP
LANGUAGE [ENGLISH]
CAPTION [OFF]
BACK LIGHT
[BRIGHT]
COLOR TEMP. [NORMAL]
DTVCC
3
Use [Cursor K/L] to select “ADD/DELETE(DTV)” or
“ADD/DELETE”, then press [ENTER].
e.g.) digital TV mode
or
--- CHANNEL SETUP ---
ADD/DELETE (DTV)
AUTO PRESET CH (DTV)
AUTO PRESET CH (TV/DTV)
AUTO PRESET CH (CATV)
! CATV takes approx. 50min.
4
Select the channel you want to add or delete. (Refer to
“Channel Selection“ on page 16.)
e.g.) digital TV mode
ADD/DELETE : DTV
D25
5
Use [Cursor s/ B] to select “ADD” or “DELETE”.
or
• To add or delete another channels, repeat steps 4-5.
• Color of channel number displayed at the right top of
the TV screen indicates;
- Blue: The selected channel will be added.
- Red: The selected channel will be deleted.
6
Press [SETUP] to exit.
5
Note:
• ”ADD/DELETE(DTV)” or “ADD/DELETE(TV)” menu will
disappear automatically in about 10 seconds.
• In the digital mode (DTV), you can add or delete channels
only for major channel.
• Once you delete a DTV channel, you cannot recover the
channel without performing auto channel scan again.
(Refer to “Auto Channel Scan” on page 14.)
Picture Adjustment
You can adjust brightness, contrast, color, tint and sharpness.
1
Press [PICTURE] to adjust the picture quality.
2
Use [Cursor K /L] to select the picture quality type you
want to adjust.
or
[BRIGHTNESS]
[CONTRAST]
[COLOR]
[TINT]
[SHARPNESS]
3
Within 5 seconds, use [Cursor s / B] to adjust the
quality.
or
Cursor 3 Cursor 4
BRIGHTNESS to decrease brightness to increase brightness
CONTRAST to decrease contract to increase contract
COLOR to decrease color to brighten color
TINT to add purple to add green
SHARPNESS to make soft to make clear
4
Press [RETURN] to exit.
Note:
• The picture adjustment setting display will automatically
disappear in 10 seconds.
5