Enviro DV50DX - Manual (Page 14)

Gas Inlet
Electrical Line
49"
(1245mm)
2 1 /
8
"
(54mm)
7 3 / 8 "
(187mm)
45"
(11
43m
m)
21
5 / 8
"
(54
9m
m)
Initial Installation
QUALIFIED INSTALLERS ONLY
I
NTRODUCTION
:
This section of the owner’s manual is for the use of qualified technicians only. Fireplace placement,
hearths, facings, mantles, and venting terminations will be covered, as well as the gas and electric
systems. There are several installation safety guidelines that must be adhered to. Please carefully read
the safety precautions at the front of this manual.
Warning: Clearances must be sufficient to allow access for maintenance and service.
P
LACEMENT
:
The location for the fireplace can be along a wall, raised or at floor level, or in a corner. There are specific
framing measurements for each situation. The basic opening should have the dimensions shown below
in Figure 15.
The fireplace must have a strong and level surface to be placed on. The surface should be made of wood
or a non-combustible material, not carpet.
The 215⁄8 inches (549 mm) dimension
takes into account the 1 inch (25 mm)
standoff on the back of the firebox. The
framing boards may touch the standoffs,
but no insulating material can be
placed between the frame and the
standoffs.
The gas line,
3 /
8
” NPT, should be brought
to the right side of the fireplace. If this
set up is inconvenient, the electrical wire
and the gas line configuration can be
reversed.
The location should be chosen so the
fireplace will be at least 36 inches (914
mm) from drapes, doors and other
combustibles. The fireplace opening
should also be at least 7 inches (178
mm) from the nearest perpendicular wall
(sidewall to the edge of the opening).
Firebox framing:
Depth 215⁄8” (549 mm)
Width 45” (1143 mm)
Height 49” (1245 mm)
Gas/Electrical Inlet:
Distance back 73⁄8” (187 mm)
Distance up 21⁄8” (54 mm)
Figure 15. Dimensions for Framing the Firebox.
14