Excalibur electronic 641S - Manual (Page 5)

8 9
INSTALLING BATTERIES
To install batteries in the transmitter, please follow these steps:
1. Remove the battery cover located on the back.
2. Install one 9-volt battery making sure to match the polarity
(+ and -) with the diagram inside the battery compartment.
3. Replace the battery cover.
To install batteries in your Beverage Buggy, please follow these
steps:
1. Remove the battery cartridge located on the underside of the
vehicle by turning the lock and lifting the cartridge off.
2. Install four AA batteries making sure to match the polarity
(+ and -) with the diagram inside the battery cartridge.
3. Replace the battery cartridge and lock the cartridge.
(Also see Battery
Information on page 9)
Changes or modifications to this unit not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Your Beverage Buggy uses a
frequency of 49 Mhz.
B
ATTERY
I
NFORMATION
• Use alkaline batteries for best performance.
• Use four AA batteries for your Beverage Buggy.
• Use one 9-volt battery for your transmitter.
• Do not use rechargeable batteries
• Do not mix old and new batteries.
• Remove exhausted batteries from the unit.
• Do not short circuit battery terminals.
• To avoid explosion or leakage, do not dispose of
batteries in a fire or attempt to recharge standard
or alkaline batteries.
• Be sure to insert batteries with the correct polarities
and always follow the toy and battery manufacturers’
instructions.
• Remove batteries and store them in a cool, dry place
when not in use.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
S
PECIAL
C
ARE
& H
ANDLING
• Avoid rough handling such as bumping or dropping.
• Avoid moisture and extreme temperatures. For best results, use
between the temperatures of 39º F and 100º F (4º C and 38º C).
• Never drive your Beverage Buggy on a wet floor, on sand, or
in mud, rain or snow.
• Be sure to remove the batteries from your Beverage Buggy
and transmitter when storing the product.