Eltax DV-252 - Manual (Page 12)

Point the remote control at the remote
sensor.
Remarks: Do not expose the remote sensor
of the DVD Player to a strong light source,
such as direct sunlight.
2. Insert batteries.
1. Open the cover.
3. Close the cover.
Make sure to match the "+" and "-" of
the batteries with the marks inside the
battery compartment.
Insert batteries Using the remote control
Notes:
Notes:
1
2
3
Improper use of batteries may cause battery
leakage and corrosion. To operate the
remote control correctly,follow the
instructions below:
Do not insert the batteries in the wrong
direction.
Do not charge, heat, open, or short-circuit
the batteries.
Do not throw batteries into a fire.
Do not leave dead batteries in the Remote
Control.
Do not use different types of batteries
together, or mix old and new batteries.
If you do not use the remote control for a
long period of time, remove the batteries to
avoid possible damage from battery
corrosion.
If the remote control does not function
correctly or the operating range becomes
reduced, replace all batteries with new
ones.
If battery leakage occurs, clean the battery
compartment, then insert new ones.
!
!
!
!
!
!
!
!
!
!
!
!
Point the remote control directly at the
player's remote sensor.
Do not leave the remote control in an
extremely hot or humid place.
Do not spill water or put anything wet
on the remote control.
Battery life is ~1 year under normal
conditions.
Remote Control Preparation
12
DISPLAY
1
ENTER
10+
2 3
4 5 6
7 8 9
0
POWER OPEN/CLOSE
AUDIO
SUBTITLE
TITLE
ANGLE
VOL
STOP PLAY
MENU
SETUP GOTO
TIME
REV PREV NEXT
ZOOM
REPEAT A-B RETURN
PROG P/N PBC
DIGEST L/R
MUTE
MODE PSCAN/ NORMAL
SLOW
PAUSE
RANDOM
FWD