Hitachi SP 18SA - Manual (Page 12)

English
12
WOOL BONNET ASSEMBLY AND DISASSEMBLY
WARNING:
Never attempt to assemble or disassemble the wool bonnet while the
polisher is capable of being turned “ON”.
Be sure power switch is in the “OFF” position and the electrical cord has
been disconnected from the receptacle.
1. Assembling (Fig. 2)
(1) Turn the polisher upsidedown so that the
spindle is facing upward.
(2) Insert the washer nut through the rubber
pad and thread it onto the spindle.
(3) Press the lock lever to secure the spindle
and tighten the washer nut with a wrench.
(4) Wrap the rubber pad with the hood of the
wool bonnet and firmly secure it by tying a
string around it. Be sure the excess string is
firmly tucked inside the wool bonnet to
prevent it from flying out while polishing.
The unbalanced fitting of the wool bonnet
may cause the vibration (Fig. 3).
CAUTION:
ⅷ Improper fitting of the wool bonnet may
cause vibration.
ⅷ Tighten the washer nut securely and confirm
that the rubber pad does not wobble.
ⅷ After releasing the lock lever, check to be
sure that it has returned to its normal
position.
2. Disassembling
To remove the wool bonnet, follow the
above-mentioned procedure in reverse
order.
Fig. 3
Fig. 2
Wrench
Spindle
Wool Bonnet
Washer Nut
Rubber Pad
Lock Lever
Tighten
Wool Bonnet