Harbor Freight Tools 37412 - Manual (Page 7)

Page 7 SKU 37412
Cutting
Warning: this tool can cause serious injury if not used properly. Read this entire
manual before using. Verify that saw blade is securely tightened and both angle
and height adjustment knobs are tight.
1. Secure rip fence or straight edge to the material to guide the saw on a straight path.
2. Place the saw base (#50) on material to be cut. Align the front notch (right edge aligns
with saw blade) on the cut line.
3. Pull the rear lock switch (safe button #45) back with the middle finger and squeeze the
switch button (#47) with the index finger. Do this before the saw blade touches the
material.
4. With the saw at full speed, move the saw slowly forward to complete the cut.
5. When the cut in complete, release the power switch button (#47). Do not set the saw
down until the blade stops turning.
Maintenance
1. Before remounting the saw blade, remove all sawdust that has accumulated around
the guard (#9), nut bolt (#1), and washer (#2).
2. Regularly inspect all mounting screws and knobs to ensure that they are properly
tightened.
3. Keep saw blades clean and sharp. Sharp blades minimize stalling and kickback.
4. Keep guards in good working order.
5. Keep motor air vent clean of dust and debris. Vacuum periodically.
6. If the tool is not operating normally, making unusual noises, or appears defective, stop
using it immediately and get it repaired.
7. Clean tool with a damp cloth and light detergent. Do not use solvents as they can
damage and crack the plastic parts.
37412.p65 10/7/03, 11:56 AM 7