Hunter Fan ICR - Manual (Page 11)


The.ICR.transmitter.requires.4.AA.alkaline.batteries..To.
install.the.batteries..remove.the.two.screws.holding.the.
battery.on.the.back.of.the.transmitter..Drop.the.batteries.
into.the.battery.compartment.and.replace.the.door..Your.
transmitter.is.now.ready.to.operate.
with.the.current.Run.Time.is.displayed..(default.is.10.
minutes).The.Run.Time.will.be.blinking.at.this.point..
If.more.than.5.seconds.go.by.
without.a.button.being.pressed,.
the.Transmitter.will.revert.back.to.
displaying.the.active.station.
3.. Use.the. .or. .buttons.to.
change.the.Run.Time.to.any.of.
the.8.settings.ranging.from.1.to.
90.minutes..Then.do.not.touch.any.of.the.buttons.for.
5.seconds.and.the.display.will.stop.blinking.and.return.
back.to.the.active.station.
insTalling THe TransmiTTer baTTeries ............................................
cHanging THe run Time ..............................................................................
You.have.the.ability.to.adjust.the.amount.of.time.that.a.
station.will.run.once.it.has.been.turned.on.by.your.ICR..
This.does.not.affect.the.run.time.programmed.into.your.
controller..This.adjustment.is.made.at.the.transmitter.as.
described.below.
To change the Run Time:
1.. If.the.unit.is.OFF.(no.display),.power.the.transmitter.by.
pressing.any.of.the.buttons.for.at.least.1.second.then.
releasing.the.button..The.transmitter.will.illuminate.and.
display.the.active.station.
2.. Press.the.Mode.button.until.the.words.“Run.Time”.along.
36/
5*.&