Home Automation Digital Whole Home Audio Distribution System - Manual (Page 13)

Page 9
IR Passthrough
When IR Passthrough is enabled, IR data can also be routed to the connected source equipment. After
decoding the received IR, the Hi-Fi processor will then route the IR signal to the source which is
logically connected to that VSC.
IR Output
Each RIM ships with an IR flasher (62A08-1). The IR flasher is used for sending IR data to the source
equipment. When you point your source equipment remote control at the IR receiver in the VSC and
send a signal, the IR data is routed to the appropriate RIM (to which the source is connected), which
then sends the IR signal through the IR flasher to the source equipment.
IR OUT
AUDIO IN
Hi-Fi RIM
Remote Input Module
IR
SOURCE EQUIPMENT
(FRONT)
IR RECEIVER
WINDOW IR FLASHER
RIM